20 Spline Yoke with Wear ring installed. Fits: XMR 1000, Maverick and '14&newer Commander style Rear differentials. These yokes are made to very tight tolerances, if you are not careful when installing these you can damage the yoke or your pinion shaft. We recommend you take your time and clean the pinion gear before installing. ---Great for custom applications--- Uses Factory size U joint (398 at the auto parts store) Part numbers 715900271 705400036
Gold / Yellow / Red 200-900 0951-1015
New OEM front differential axle seal
Outer diameter is 47mm
Inner Diameter is 25mm
Part numbers: 705401486 705401618
Can Am Maverick 1000R secondary spreader M25x1.5 thread size, to verify fitment 100% measure your clutch where this threads in. This will only fit Quick Response System (QRS) Secondary clutches, as pictured. This style of driven clutch is found on 2015-2018 1000R Turbo Mavericks and the 2017-2018 XMR Mavericks This will NOT work on the Maverick X3/Sport/Trail models please see our other listings for those. Bolt is included Part number 708200504
This is the NEW OEM factory gauge support from the 2020+ Outlander XTP and LTD models. For use with large 7.6" LCD display Part Number: 705013984
New Genuine OEM IACV idle air control valve bypass, this is what controls the idle speed of your ATV. Will fit on most any Vtwin 2006-current Can Am Outlander Renegade models. Will not fit 850 or 1000R engines with the 54mm throttle body. Old part numbers 420665940 420963055 420963057 Current part number 420665941
New NGK Spark Plug
OEM part number 715900357
NGK part number LMAR9D-J
These spark plugs work in 2015-2017 Maverick TURBO machines only (will not work in the X3)
Shell
Thread Size: 10mm
Thread Pitch: 1.0mm
Seat Type: Gasket
Resistor Value: 5K Ohm
Reach: 26.5mm (1.04″)
Hex Size: 9/16″ (14mm)
Terminal Type: Solid
Overall Height: ISO
Gap: .031″ (0.8mm)Center Electrode
Material: Nickel
Type: Standard
Size: 2.5mm
Projection: ProjectedGround Electrode
Material: Nickel
Type: Multi-Ground
Spicer Brand U joint for front drive shafts Fits: G1 Renegade and Outlander . Also works on Outlander 400 Rear shafts. Maverick/Commander front driveshafts Will not fit: Maverick X3/Sport/Trail or Defender Includes clips, and grease fitting. Pro tip: Install grease fitting before pressing in u joint. Install u joint in a manner where you can still grease the joint in chassis. Replaces OEM : 715900325 703000023 703000024 703500002 703500135 703500607 703500814
Please verify your differential uses this style of seals before ordering! Can Am Rear Differential Pinion and Axle Seals (Timken or SKF) Fit on most 2006-2013 Outlanders and Renegades The Pinion Seal has a 70mm Outer Diameter And the standard 37mm inner diameter. The Axle Seal has a 47mm Outer Diameter And the standard 30mm inner diameter. Complete Seal kit for Standard Rear differentials Replaces OEM Numbers: 705400027 705500751 705501996 705401481
Mohawk Dash for Can-Am Renegade Will work all Renegades G1 or G2. up to 2020 Clean way to hide custom snorkels Factory OEM part 705009685
New Genuine OEM handle for your commander cargo box. Will work on the upper tail gate or lower cargo door Part number 708300398
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit.
Ultra convenient “all in one” kit saves time and money.
For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest.
Not compatible with Maverick X3
Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 10W50, 0-rings, rotax oil filter, and copper washer for both old style and new style drain plugs.
10w50 oil, great for hot climates, temperature range -13*F to 122*F
May not ship in original box
Part Number: 9779252 779252
New Genuine OEM wheel stud Works on 2017-2020 Maverick X3 machines Part number 250300625
250 900 0951-1037
SHIPS FREE TO THE LOWER 48 STATES Can-am Commander style CVT cover set. This is the 13 bolt cover set, with attached reflective heat foam. Fits: Commander 800R two seat 2011-2020 Commander 800R MAX four seat 2016 Commander 1000 two seat 2011-2017 This kit will keep the water out! Comes with: Commander covers inner and outer. CVT Cover Gasket CVT Drain plug and Clamp Engine O-ring Gear box O-ring Inner CVT Bolts/Nut 13 Cover screws Part numbers: 420612472 715900200 420611407 420440568 420430408 420631088 420430126 420440567 420440568
New Genuine OEM Can-Am 4 Wheel Drive Switch This selects the two wheel drive or four wheel drive on your SXS This is a two position rocker switch. Fits Commander, Maverick and Maverick Turbo Will not fit Maverick X3/Sport/Trail If you aren’t sure if this will fit, please ask, we will help! Part number 710001737
Standard Differential Pinion Seal. Please check your wear ring, if that is grooved it is time to replace. Very easy to miss that and blame a new seal on a bad wear ring. Will fit: G1 Front and Rear Differentials 2012-18 Outlander and Renegade Front and Rear Differentials All Commander Front Differentials 2011-13 Commander Rear Differentials 2013-18 Maverick Front Differentials (non X3/trail/sport) WILL NOT FIT G2 XMR 800/850/1000 REAR DIFFERENTIAL Measurements are shown: 70mm outside and 37mm inside Replaces part numbers 705401481 and 705401615
Can Am Trailing Arm Nut Removal Tool, Spanner Socket
Part # 529035925 Brand New, We recommend using heat on the nut as well.
DO NOT use an impact gun on the nut as you risk breaking the tool. We have done many with a large breaker bar.
Six Weights 14 gram each for CVtech Trailbloc Primary Part numbers: 0935-2005 or 0901-7105
Can-Am 703500865 Secondary Clutch Driven Pulley Stud Nut Screw Kit Secondary Stud/Nut Kit M10x136mm You will need to reuse your washer. This kit will work on every Vtwin ATV factory driven (secondary) clutch (pulley) Also fits Commander driven clutch Will work on non QRS Maverick driven clutch If you have fitment questions, please contact us, we are here to help. Part numbers: 703500865 420441900 420242097 420242402
CVtech Slider Shoe HD set of three for billet plate 0930-2004
NEW OEM Timing Chain Housing O ring Order two per Vtwin engine Part number 420430370 420430373
neapco Brand U joint for front drive shafts These U joints are made in Italy, please do not confuse these with the sub-grade china made u joints. Fits: G1 Renegade and Outlander . Also works on Outlander 400 Rear shafts. Maverick/Commander front driveshafts Will not fit: Maverick X3/Sport/Trail or Defender Includes clips, and grease fitting. Pro tip: Install grease fitting before pressing in u joint. Install u joint in a manner where you can still grease the joint in chassis. Replaces OEM : 715900325 703000023 703000024 703500002 703500135 703500607 703500814
Can-am OEM PTO and crankcase bearing install and removal tools. These are the OEM tools required to install bearings in the bottom end of your Can-am V twin engine correctly. Part Numbers 529035917 & 529036032
All Balls Fuel pump rebuild kit, with pick up screens and hoses.
Fits most every can-am efi v-twin application. Including the hard to find bottom feed early G1’s
WILL NOT FIT 570 OR Defender HD5
24-72015 47-2015 Replaces OEM numbers: 703500771 709000245 703500766 709000287
New OEM 18 spline yoke with fully machined surface This is the forward most yoke on the rear driveshaft of G1 ATVs Fits years 2006 and newer, 450 and larger machines, if you are unsure on fitment please contact us. Use with 398 type U joints Current Part number 715900101 Replaces 705500371 705501372
Dash/Speedometer for 2008-2012 Outlander 500 650 and 800 MAX or STD . This is the factory Gauge.
The dash is designed to auto pair, but sometimes it will not auto pair and you will have to program them together with buds software. This can be done at your local dealer or you can send in your ecu, key(s), and DPS (power steering) to us for programming. Contact for more information.
It will display 0 miles, please record your current miles for your records.
If you are looking for a dash (715900042) for your 06-07 V twin Outlander, this will retro fit. Click here for the guide on the Analog To Digi Dash Repin
Current part number: 710003100
Replaces part numbers: 710001472 710001527 710001978 710001985 710002178 710002474 710001068
Brand NEW Genuine OEM Upper Ball Joint For G2 ATV , 2012-Current Commander and Maverick Will not Fit Maverick X3/Trail/Sport Does NOT include Circlip, Cotter Pin, Hardened Washer, or M12 Nut. Be sure to save your old ones Part Numbers: 706200741 706201370 706201394 706202044
Moose Racing Air Filter Part Number 1011-2796 Fits SXS pictured: Commanders 800/1000 and Maverick 1000R (non turbo) (non X3/Sport/Trail) Engineered for maximum air flow, increasing horsepower Maintains premium protection by stopping the finest dust particles Flexible seams that will not crack Filters are designed to fit all stock air boxes Made in the U.S.A. Replaces OEM 707800327
OEM O ring this seals the gearbox oil, it is installed on the rear through shaft bearing housing. Roughly two inches in diameter. Part Number 420230306 replaces 420230305
NEW OEM Can-Am Variator CVT Clutch Outer Cover Belt Box This part is made for 2016-current Outlander and Renegade 1000R’s Perfect for a machine with a larger aftermarket clutch or any machine using a Maverick Primary with a stud/nut, as this cover has more room inside. **NOTE: This cover does not have any extra venting holes** Current Part number: 420612316 Old Part number: 420612310
New XPS SAE 75W-140 Synthetic Gear Oil Kit. Enough to do a complete service on the front differential, rear differential, and gear box 1 U.S QT 946ml per bottle Listing is for 2 Quarts. See your owners manual before ordering to make sure you order the correct weight for your Can Am Part number 779160
BOYESEN SUPERCOOLER WATER PUMP Cover and Impeller Kit Increased coolant flow at all rpm ranges Patented Nautilus-style impeller for hydrodynamic efficiency Color/Finish: Black, Powder-Coated Material: Aluminum Model: Supercooler Part number 0932-0166 WPK-80B Replaces OEM 420222505 420222785 703501124 This is the style with the smaller output nipple roughly 7/8 inch in outer diameter.
Brand New Genuine OEM BRP logo sticker 68mm size
New OEM driveshaft dust protector Protects the gearbox seal Current part number 705501123 Replaces 705500678 and 705500902
NEW Genuine OEM Can-am Rear Prop Shaft for 2012-14 Outlander 1000 NON XMR NON MAX Or 2012-18 Renegade 1000/1000R. NON XMR Comes with protector ring installed. Wear ring is not needed or included on this shaft. The yoke is simply machined larger in outer diameter. If you have any doubts about fitment, please count your splines on your gearbox output shaft and the pinion shaft on your differential. This shaft is for 20 spline gearbox output shaft and 18 spline rear differential. Current Part number: 703500991 Replaces Part Numbers: 703500929 703500862 705501413 705501258
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.