NEW OEM Can-am Defender, Maverick Sport/Trail or Maverick X3 front differential pinion seal. This is pressed into the front differential and seals against the front driveshaft. Measurements are : 79mm outside and 25mm inside 8mm thick Part number 705401827
NEW OEM Shim Kit for standard pinion gears. Wide Range of shims, this will allow you to set up your pinion depth. 37mm Outer Diameter. 27.45mm Inner Diameter. This is a loose fit Fits Front or Rear Standard Differentials Part number 705502061
NEW OEM Canam PPS Sport Mode Switch Part number 710002199 Fits: 2011-2013 Commander 1000 and 800R 2013 Maverick 1000R Amber backlight
Brand New Genuine OEM Friction Washer Goes between Ball Bearing and Spring Seat on the Drive Pulley Clutch This is needed for correct engine braking on many models, not sure if you need it, please ask! OEM Part number: 420460430
Can-am OEM tool. High-quality, heat-treated steel for superior strength. A tool needed to pull primary clutches off the crank shaft taper. Part Number: 529035746
Brand New OEM PTO Cover Gasket for V-Twin Engines Part number 420651211
NEW Push to start button Genuine OEM button Will work on 2011-2020 Commander and Commander Max and 2013-2018 Maverick and Maverick Max Part number 710002594
Brand New Genuine OEM front differential This is the power steering model which has the quick engagement
Will work on both power steering and non power steering machines
Fits 2012- Current Outlanders and Renegades (minus electronic locking type front differentials)
Also Fits 2011-2020 Commander Commander MAX and 2013-2017 Maverick and Maverick MaxOld part numbers 703500900, 705401241, 705401480, 705401483, 705401485, 705401488, 705401511, and 705402181
Current part number 703500908You will need to transfer over your fill plug
2013-2019 driveshaft for Outlander Max machines New Genuine OEM Old Part Numbers 703500863 703500926 Current Part Number 703500987 18 Spline end yokes. Perfect for machines with a small gearbox and a standard rear differential.
Updated Can-am Rear G2 Driveshaft Fits: 2019+ Outlander 1000R (excluding MAX and XMR) 2019+ Outlander 650/850 (excluding MAX) 2019+ Renegade 650/850 All new all OEM Shaft OEM U-joints. OEM protector ring installed Gearbox side yoke swapped to 18 spline Current Part number: 703500988 Previous Part number: 703500858 703500931 If you have a 2019+ 570 short wheel base single rider, this may be the correct shaft for your application, the parts fiche may not show the correct part number. You will need to measure the outer diameter of your rear differential's pinon seal, this shaft will only work with machines that have a 80mm pinion seal. If you measure 70mm you will need 703500986. 20 spline differential side yoke (fits 705502808/705502546 rear differential) 18 spline gearbox side yoke (small gearbox size) No wear ring needed, the deferential side yoke is machined to the outer diameter that a wear ring would be.
Can-am Rear Driveshaft G2 2019+ G2 Renegade 1000R base, XXC or XMR All New All OEM Shaft OEM U-joints, with OEM gearbox seal protector installed. **Please note, this is the most updated shaft and does not require a wear ring on the differential side of the shaft. The last two pictures illustrate this.** 20 Spline Gearbox side yoke (fits large type gearboxes) 20 Spline Differential side yoke (fits fits 705502808/705502546 rear differential) Current Part number: 703500990 Previous Part number: 703500928 703500901
New OEM Canam Commander 800 or 1000 rear driveshaft. We install the wear sleeve and protector to make it a straight forward install for you! This is an OEM can am shaft, do not confuse this with sub grade Chinese products. If you have a 2011-13 commander 800 or 1000, please understand the 2014-new commander rear propshaft will not fit! They have a different rear differential. We here at CPG understand the newer shafts are much cheaper, we do not know why there is such a price difference. *Will not fit Commanders with Electric Unlocking rear differentials (this is a rare option, you will have a switch on the dash) 20 spline gearbox end yoke 18 spline differential end yoke Roughly 6 1/4? center of weld to center of weld. Current Part Number: 703500805 Previous Part number: 703500762 705501257
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.