MOOSE UTILITY Shifter Cable Part Number 0652-2421 Replaces OEM number 707001210 Heavy-duty stainless steel end fittings at both ends for corrosion resistance and longevity Roughly 53 inches long from end to end Fits two seat models: 2016-2020 Commander 800R 2016-2020 Commander 1000/1000R 2016-2018 Maverick 1000R
MOOSE UTILITY Shifter Cable Part Number 0652-2422 Replaces OEM number 707001283 Heavy-duty stainless steel end fittings at both ends for corrosion resistance and longevity Roughly 83 inches long from end to end Fits Four seat MAX models: 2016-2020 Commander MAX 800R 2016-2020 Commander MAX 1000/1000R 2016-2018 Maverick MAX 1000R
MOOSE UTILITY Shifter Cable Part Number 0652-2894 Replaces OEM number 707000775 Heavy-duty stainless steel end fittings at both ends for corrosion resistance and longevity Roughly 53 inches long from end to end Fits two seat models: 2011-15 Commander 800R/1000 2013-15 Maverick 1000R
XPS SAE 75W-90 Synthetic Gear Oil Kit. Enough to do a complete service on the front differential, rear differential, and gear box. 1 U.S QT 946ml per bottle This listing is for 2 quarts See your owners manual before ordering to make sure you order the correct weight for your Can Am 779158
New Maverick rear differential pinion housing nut socket tool. This tool will remove the nut that screws into the aluminum housing. Applying heat to the nut/housing is recommended before using this tool. There is no warranty with this tool. The nut should be left hand threaded, meaning turning counterclockwise will tighten the nut where clockwise will loosen it. Half inch drive socket. It is recommended to only use hand tools with this. Diameter (Exterior) 2 7/8" Diameter (Interior) 2 1/2"
High quality aftermarket Timken or SKF axle oil seal. Fits ATV rear differentials 2015-current, some UTV’s To be 100% sure on fitment, measure your outer diameter on your seal, it should read 52mm This seal has a 30mm inner diameter 52mm outer diamter and is 8mm thick. Replaces OEM 705501556 Order qty two per machine.
New Aftermarket Bellows with clamp, use this in place of vent lines on your differentials. Replaces OEM part number: 705400352
Can-am Maverick Rear differential shim kit. Needed when changing gears in your maverick rear differential. Part Number: 703500839
IKO bearing replaces OEM 703500840
NEW Spanner Wrench This is to remove and install the nut on 703500867 pinion assembly. Use a 20 spline yoke to retain the assembly in a vice and spin the nut off. The nut should be RH threaded
SHIPS FREE TO THE LOWER 48 STATES New Can Am Maverick or Commander Gear Box New Can-Am GEAR BOX this is the way to reduce the over all gear ratio on your can-am 1000 running larger tires. Current Part Number- 420686654 Replaces: 420686563, 420686562 & 420685807 NEW OEM Canam Part NOT A REBUILD, ALL NEW Brand New In The Box This is the LOW RATIO gearbox for the larger style gearbox equipped machines, please ask if you are unsure about fitment. **Top speed on our 2012 Commander 1000 is 62 mph (high range) with this gearbox and stock clutching and stock size tires** Gearbox ratios, this isn’t regurgitated info, this is us counting teeth inside of the gearbox. Ring and Pinon Gears 37/15=2.467 Intermediate 45/40=1.125 High Range 36/27=1.333 Low Range 46/17=2.706 Reverse 34/12=2.833 High Range Ratio 3.700 Low Range Ratio 7.509 Reverse Ratio 7.863- OUT OF STOCK
SHIPS FREE TO THE LOWER 48 STATES Rear Differential Rebuild Kit for 2013-2018 "OG" Maverick 1000R/Turbo Rear Differentials. Will not fit X3 Trail or Sport Mavericks. You will need to shim this to your cases like any other gear set. Factory BRP: gears, roller bearings, pinion seal, washer and shims. IKO needle bearing, SKF or Timken axle seals, aftermarket driveshaft bolt. Replaces oem 703500840 703500869 703500867 703500868 703500837 705502275 705501556 
New IKO, Koyo or NTN brand needle bearing B98 replaces 705500261 If you are unsure on fitment please reach out to us we will help.
SHIPS FREE TO THE LOWER 48 STATES High Quality aftermarket Bearing and Seal kit for Maverick 1000R/Turbo Rear Differentials. IKO, SKF, KOYO, FAG and Timken brands found in this kit. Replaces oem 703500840 703500869
New Can Am Maverick Rear Differential Pinion Seal This is a New Genuine OEM seal Part number 705501933 New updated part number 705502276 Press fit into differential, then seals against wear ring (if your driveshaft requires one) If your wear ring is grooved you should replace it.
Outlander Renegade Commander Maverick Differential Drain Plug Brand New Genuine OEM Drain Plug 9.9 mm outside diameter Will fit on some fronts and rears be sure yours looks like this one and measures the same Part Number 705500894
Brand New Genuine OEM Fill Level Plug Be sure that yours looks the same due to other styles for front or rear differential from different years M14 diameter 1.5 thread pitch Part number 705500504
Cam Am rubber bellow for front or rear differential. This is a brand new OEM rubber bellows. Part number 705400352
OEM O ring this seals the gearbox oil, it is installed on the rear through shaft bearing housing. Roughly two inches in diameter. Part Number 420230306 replaces 420230305
New Can Am Maverick 1000R Rear Differential Replaces Rear differential in any Maverick/Maverick Turbo (non X3/Sport/Trail) Largest and strongest rear differential found in Can-am’s 10/36 Gear set, that is a 3.60:1 ratio, same since at least 2006 Pinion shaft 20 spline Current Part Number 705502275 Old Part Numbers 705501912 705501958
Cam-Am Maverick Rear Differential Pinion Gear Fits 2013-2018 Maverick Turbo or non turbo Will not fit X3/Sport/Trail Models Comes with Pinion and Bearings Part Number: 703500867
New Can Am Maverick 1000R Rear Differential KIT ready for your custom install. New OEM Can-Am Rear Differential New OEM Yoke Updated style that does not require a wear ring (uses standard 398 U joint) New Bolt and washer Replaces Rear differential in any Maverick/Maverick Turbo (non X3/Sport/Trail) Largest and strongest rear differential found in Can-am’s 10/36 Gear set, that is a 3.60:1 ratio, same since at least 2006 Pinion shaft 20 spline Current Part Number 705502275 Old Part Numbers 705501912 705501958
OEM oring commonly used on distance ring on gearbox input shaft. 420631610 replaces 420631615
New OEM front differential axle seal
Outer diameter is 47mm
Inner Diameter is 25mm
Part numbers: 705401486 705401618
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.