NEW OEM Wheel Center Cap Commander/Defender Style Please understand there are different styles of caps. This style fits on to the wheel not the hub. The last picture shows this installed. Please look for the part number on your other caps to verify fitment. Part number 705401541
NEW OEM Shim Kit for standard pinion gears. Wide Range of shims, this will allow you to set up your pinion depth. 37mm Outer Diameter. 27.45mm Inner Diameter. This is a loose fit Fits Front or Rear Standard Differentials Part number 705502061
NEW OEM Wheel Center Cap Set of Four Commander/Defender Style Please understand there are different styles of caps. This style fits on to the wheel not the hub. The last picture shows this installed. Please look for the part number on your other caps to verify fitment. Part number 705401541
Brand New Genuine OEM Rubber Boot Fits Commanders Mavericks Outlanders Renegades Used for sliding joints Part number 715900118
Can Am Commander or Maverick Wheel Stud M10 Stud diameter 27.5mm spacing for brake rotor Part number 250300060 replaces 250300051
Can Am Maverick 1000R secondary spreader M25x1.5 thread size, to verify fitment 100% measure your clutch where this threads in. This will only fit Quick Response System (QRS) Secondary clutches, as pictured. This style of driven clutch is found on 2015-2018 1000R Turbo Mavericks and the 2017-2018 XMR Mavericks This will NOT work on the Maverick X3/Sport/Trail models please see our other listings for those. Bolt is included Part number 708200504
Can Am Maverick X3 center cap axle nut cover WILL ONLY WORK ON MAVERICK X3 This mounts to the wheel hub, not the wheel. Part number 705401841
1652 NEW OEM Needle bearing 16x22x19 Size These are OEM Canam Bearings high quality brands like NTN are used. 16mm Inner Diameter 22mm Outer Diameter 19mm Long Part number 705502058
Primary Clutch rebuild kit QuadBoss/All Balls Brand. NEW Great value fits all Canam v twin ATV’s Part number 411171, 22-51716, 25-1716, 237251716, 1132-1006, 125-1716, 7560847, 209320, 134044 Replaces oem numbers: 420632375 420245951 420229577 420239133 420239134
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit.
Ultra convenient “all in one” kit saves time and money.
For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest.
Not compatible with Maverick X3
Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 5W40, 0-rings, rotax oil filter, and copper washer for old style and new style drain plugs.
May not ship in original box
Part Number: 779258 replaced by 9779488
Brand New Genuine OEM Fill Level Plug Be sure that yours looks the same due to other styles for front or rear differential from different years M14 diameter 1.5 thread pitch Part number 705500504
Moose Racing Air Filter Part Number 1011-2796 Fits SXS pictured: Commanders 800/1000 and Maverick 1000R (non turbo) (non X3/Sport/Trail) Engineered for maximum air flow, increasing horsepower Maintains premium protection by stopping the finest dust particles Flexible seams that will not crack Filters are designed to fit all stock air boxes Made in the U.S.A. Replaces OEM 707800327- OUT OF STOCK
Ultra-convenient “all-in-one” oil change kit saves time and money.
Includes XPS Synthetic Blend Oil, oil filter, o-rings and washer.
900 ACE engines found in the Maverick X3 line
SAE 5W-40 4T Oil
Complete oil change kit
Part number 779260
Will not fit Vtwin applications
This is the 2019+ rear differential found in Renegades and Outlanders 650 and larger This has the 6 inch (155mm) ring gear with straight cut teeth as shown. It will fit g2 bikes (500/650/800/1000) if you are upgrading you will need to shorten your shaft 1.75 inches or buy a kit from us, please see our other listings. (G1 bikes will require further modifications to work). This has a provision for an abs sensor, but will fit bikes without a rear diff sensor BRP claims 25% increase in load capacity on this gear set vs the spiral cut xmr final drive units (rear differentials) from 13-18 models. Pinion spline count 20 Current part number 705502808
New OEM can-am input or output seal for small gear boxes You will need two per gearbox. 32mm inner diameter 47mm outer diameter 7mm thick Current Part Number 420950089 Replaces Part Number 420950087
NEW OEM Can-am Output Crank Shaft Seal This is the engine out put shaft seal, pressed into the crankcase PTO cover 34mm Inner Diameter 52mm Outer Diameter 8mm Thick Current Part Number 420631933 Replaces Part Number 420631932
SHIPS FREE TO THE LOWER 48 STATES! Can-am NEW OEM Main bearing set. Kit includes: Main Bearing Half with Oil hole 420233965 x2 Main Bearing Half without Oil hole 420233960 x2 PTO Cover Bearing 420233995 Be sure to mark your cases before pressing them out! The oil holes need to be lined up!
BOYESEN SUPERCOOLER WATER PUMP Cover and Impeller Kit Increased coolant flow at all rpm ranges Patented Nautilus-style impeller for hydrodynamic efficiency Color/Finish: Black, Powder-Coated Material: Aluminum Model: Supercooler Part number 0932-0166 WPK-80B Replaces OEM 420222505 420222785 703501124 This is the style with the smaller output nipple roughly 7/8 inch in outer diameter.
Can Am Commander 800/1000 rear differential Pinion Oil Seal This is a genuine OEM oil seal 90mm outer diameter 37mm inner diameter Will come as pictured Part Number 705501878
Can Am Commander 800/1000 rear differential oil seal This is a genuine OEM oil seal 55mm outer diameter 30mm inner diameter Will come as pictured Part Number 705502110 replaces 705501879
OEM O ring this seals the gearbox oil, it is installed on the rear through shaft bearing housing. Roughly two inches in diameter. Part Number 420230306 replaces 420230305
Driven Pulley Extractor bolt for belt changes This spreads the secondary with the 708200686 adapter tool. Works with: Can Am Defender HD8 HD10 Part number 529036352
SHIPS FREE TO THE LOWER 48 STATES Brackets for swapping in a Maverick Rear Differential in your Commander. USA Made Black powder coat MIG welded steel brackets.
SHIPS FREE TO THE LOWER 48 STATES OEM Can am Shaft cut to length for use with our maverick swap kit in your commander.
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.