- OUT OF STOCK
Can Am Outlander Renegade Power Steering Pitman Arm Will work on 2012-2017 500 650 800 1000 Gen 2 machines Part numbers 703500785 703500812 
Spicer Brand U joint for front drive shafts
Fits: G1 Renegade and Outlander . Also works on Outlander 400 Rear shafts.
Maverick/Commander front driveshaftsWill not fit: Maverick X3/Sport/Trail or Defender
Includes clips, and grease fitting.
Pro tip: Install grease fitting before pressing in u joint.
Install u joint in a manner where you can still grease the joint in chassis.Replaces OEM : 715900325 703000023 703000024 703500002 703500135 703500607 703500814
Cast Aluminum Valve cover set with Stainless bolts. Replaces your factory plastic valve covers on any can-am V-twin ATV or UTV 500/570/650/800/850/1000/1000R Replaces OE Numbers: 420610390 420610394 420610393 420610395- OUT OF STOCK
New OEM Differential Pinion Oil Seal. Please check your wear ring, if that is grooved it is time to replace. Very easy to miss that and blame a new seal on a bad wear ring. Will fit: Gen 1 Front and Rear Diffs 2012-18 Outlander and Renegade Front and Rear Early Commander Rear All Maverick and Commander Front WILL NOT FIT G2 XMR 800/850/1000 REAR DIFFERENTIAL or 2019 and newer Measurements: 70mm outside diameter and 37mm inside diameter Part number 705401615 
Canam CVT Cover Kit Commander/Maverick 1000R
Please look at pictures to verify fitment.
This outer cover has two breather holes, one in front of the primary, one on the secondary.
This outer cover is the factory replacement for 420612319, some aftermarket clutches will not clear the new breather hole style you may need to modify this cover or backdate it to the 420612313 style with out the secondary breather.
Please look at pictures to verify fitment.
Fits:
Commander 1000R two seat 2018-2020
Commander 1000R MAX four seat 2018
Maverick 1000R two seat 2014-2018
Maverick 1000R MAX four seat 2014-2018Will not fit:
2015-2018 Maverick 1000R Turbo
2017-2018 Maverick 1000R XMRInner cover 420612304
Outer cover 420212286
13 Hex head CVT housing bolts 420440568
Gasket 420430126
O-rings – 420430407 and 420631087
Hex Bolts – 420440207
Also has a nut and washer – 232561434, 224061121
Nylon drain plug and clamp
Can Am 2016 2017 Maverick Turbo Brown Fuel Injector Genuine OEM Part Part number: 420274255- OUT OF STOCK
Brand New Moose Utility left or right rear axle Will fit CAN AM Maverick 1000 2013-2015 Low profile stainless steel clamps Engineered in the USA Part Number: 0214-1145 Replaces OE Number: 705501948 705502356 - Sale!OUT OF STOCK
Brand New Moose Utility Division Left or Right Rear Axle Will fit CAN AM Commander 800 and 1000 2013-2015 Low profile stainless steel clamps Engineered in the USA Part Number: 0214-1003 Replaces OE Number: 705500960 705502359 705501456 705501481 
Part Number 0934-4824 Fits: 2006-2012 G1 800HO or 800R Outlander/Renegade Complete Engine Gasket kit made by Moose Racing Gasket kit
CVTech Primary Clutch Holding tool. Very nice tool for torquing nut on the clutch or the bolt holding clutch on to the crankshaft taper. 0155-1018 Part number
EPI Bushing Kit, steel inner, plastic outer bushings and shimsFits: G2 Canam ATV’s Outlander or RenegadeDefender and CommanderIf you are unsure on fitment, please contact us before purchasing!Exact replacement components to return your suspension to like-new conditionKits are sold per A-armEPI Part Number: WE341052P/U Part Number: 0430-1029Replaces OEM Part Numbers: 703500875 706202088 706202089 706202133
SHIPS FREE TO THE LOWER 48 SATES Can-am 2013 1000R Maverick Commander style CVT covers. This is the 13 bolt cover set. Popular for aftermarket clutch set ups. Only one breather hole in front of the primary clutch works on non Turbo Machines This kit will keep the water out! Comes with: 2013 Maverick 1000R covers inner and outer. CVT Cover Gasket CVT plug PTO O-ring Gear box O-ring Inner CVT Bolts/Nut 13 Cover screws Part Numbers: 420612312 420612313 420611407 420440568
CVT cover set for Turbo V twin Mavericks 1000R Best to pull your cover and visually inspect it for fitment. This cover has two holes over the primary clutch and one over the secondary. If you are unsure on fitment, please contact us! Fits: 2015-2018 Maverick 1000R Turbo 2017-2018 Maverick 1000R XMR Will not fit Maverick X3 Comes with: Maverick Turbo covers inner and outer. CVT Cover Gasket CVT plug PTO O-ring Gear box O-ring Inner CVT Bolts/Nut 13 Cover screws Part numbers 420212285 420611407 420440568
Differential Vent Tube 8mm diameter Part number 705501584
OEM Number 705501557 Pinion seal found on G2 800 850 1000 1000R XMR rear differentials 38mm Inner Diameter 80mm Outer Diameter 10mm wide
Fits G2 ATV’s Outlander or Renegade 500 450 570 650 800 850 1000 1000R
Shift Arm Base Upgrade
Replaces OEM 707003054 707000971 707002439
USA made Made from 6061 T6 Aluminum (aircraft grade)
This plate does not require any additional hardware, use a zip tie to retain the wire harness or vent lines running near it.
Early Commander Steering Rack Great Value for replacing a worn out rack. Moose Number 0430-1071 Replaces OEM 709401185 Fits 2011-2014 Commander 800/1000 Be sure to center rack before installing your steering shaft.
NEW Can Am OEM Cam Timing Tool For holding the cam in place for timing and tightening camshaft sprocket bolts For easy installation of new timing chains or just setting timing. OEM Number 529036268 replaces 529036231
NEW OEM CVT cover with heat shield installed from factory
Fits:
Maverick 1000R two seat 2013-2014
Commander 1000 MAX four seat 2014-2016
Commander 800R MAX four seat 2017-2019ONE Breather hole in front of Primary clutch.
This is the cover with the most room. Common to use this on newer V-twin 1000R Mavericks with aftermarket clutches that do not require the extra breathers.
Please match this up with yours before purchasing.
Part number 420612318
Replaces 420612312 420612313 715900257 420975052
Can Am G2 Outlander low beam head light **Will not work on G2L models (steel racks, single housings)** Fits 2012-2019 Can Am Outlander G2 (plastic racks four headlights) Part Number: 710002191 710006177
NGK 4339 DCPR8E Standard Plug Fits All G1 ATV's OE numbers: 707000246 715900637 Thread Size: 12mm Thread Pitch: 1.25mm Seat Type: Gasket Resistor Value: 5K Ohm Reach: 19mm (3/4") Hex Size: 5/8" (16mm) Terminal Type: Removable Nut (you will need to remove this for use on G1 ATV's) Gap: .028" (0.7mm) Torque Specs Aluminum: 10.8-14.5 lb. ft. Brand: NGK Heat Range: 8 Longevity: 30k Miles Resistor: Yes Projected Material: Nickel Quantity: 1
Plain bearing half 40 X 43 X 15 This fits into one side of the connecting rod. part number 420233980
Can Am Outlander 500 650 piston ring set New Genuine OEM Kit is only for one piston Current part number 420684384 Old part number 420684114
Can-am Rubber Trailing Arm cover and Oetiker clamp for your G1 Outlander or Renegade Will only work on the gen 1 Outlander and Renegades 2006-11 and some 2012 models. If you are unsure on fitment, please ask. You will need to order qty 2 to replace both sides. Genuine OEM parts Part Numbers: 706000222 706000749 293650162
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.