New Genuine OEM CVT Air Outlet Adapter Boot Fits 2013-2020 Outlander, 2015-2020 Renegade 570,650,800,850, and 1000 Product Number: 707001168
Plain bearing half 40 X 43 X 15 This fits into one side of the connecting rod. part number 420233980
CVtech Centering Washer Use with M12 retaining bolts on the trail bloc primary (drive) clutch Part number 0080-0170 28mm outer diameter
Moose 20amp four pin relay Replaces OE number 710001778
Six Weights 12 gram each for CVtech Trailbloc Primary Part numbers: 0935-2004 0901-7104
Moose Racing Radiator Cap Fits Outlander, Renegade, Commander, Defender and Maverick Unsure on fitment, please ask us. Cap is set to the same 15.9PSI as stock. If you current cap is not holding pressure replacing with new will help avoid overheating. Replaces OEM 709200207 709200033
Can-am Outer CVT Cover, belt box. This is the updated 13 bolt cover. Works with 7 or 13 bolt inner covers. This will fit on any 2006-current v twin ATV, Renegade or Outlander, 500 650 800 or 1000. If you have a a stud with a nut retaining your primary clutch this cover does not have the depth needed. Many 1000R machines use a stud/nut in place of the bolt. Unsure on fitment, please ask! This will keep the water out! 13 Cover bolt holes Current Part number is: 420611397 Replaces: 420611395, 420611390, 420611391, 420611393
SHIPS FREE TO THE LOWER 48 STATES Late G1 Early G2 Standard Rear Differential Bearing and Seal Kit High quality aftermarket bearings along with double lip axle seals. Bearing and Seal Brands include: Nachi, KOYO, NTN, Timken The large case sealing and pinion gear O-rings are NOT included as a cost saving measure, these O-rings are reusable if not damaged. There are a few options for kits, please verify your differential uses this style of gears before ordering! This will only fit six mounting hole differentials. Open up the differential! Check for two bearings total (one on each side) on the ring gear. If you only have two proceed to the next measurement. Measure your outer diameter of your axle seals! They should measure close to 1 3/4" (47mm) To further verify fitment you can measure your pinion pilot shaft, this should be 9/16″ (14mm) The last pictures show this very clearly. Please take the time to measure your parts before buying this will save time and restocking fees.
Wind deflector mounting kit with hardware. Fits Outlander Renegade & DS450. For use with OEM wind deflectors This is just the mounting kit. Part number 715001378 No wind deflectors included.
- OUT OF STOCK
Air Pressure sensor, this goes in the Black plastic Intake manifold. Will work on any 2006 to current Can am Outlander, Renegade, Commander, Maverick, Defender 500 570 650 800 850 1000 XT XMR MAX or XXC The Manifold Absolute Pressure sensor or MAP sensor is a sensor that is attached to the intake manifold. The MAP sensor responds to changes in the intake manifold pressure (vacuum) and provides a reading of engine load. How it works is 5 volts DC is supplied to the sensor from the ECU. Inside the MAP sensor there is a resistor that moves in relation to intake manifold pressure. The resistor varies the voltage between about 1V to 4.5V (depending on engine load) and that voltage signal is returned to the PCM to indicate manifold pressure (vacuum). This signal is essential for the PCM to determine fuel delivery. Part numbers: 420874650 707000564 707000995 0 261 230 030 ALFA ROMEO 46553045 ALFA ROMEO 46533518 CHERY S21-3614021 FIAT 46553045 FIAT 77364869 FIAT 7084986 FIAT 0000046553045 FIAT 46533518 LANCIA 46533518 LANCIA 0000046553045 LANCIA 46553045 MOOSE 2120-0994 PROTON PW810694 ROTAX (BOMBARDIER-ROTAX GMBH) 874 650 SCANIA 5166434 
NEW OEM Can-am Output Crank Shaft Seal This is the engine out put shaft seal, pressed into the crankcase PTO cover 34mm Inner Diameter 52mm Outer Diameter 8mm Thick Current Part Number 420631933 Replaces Part Number 420631932
SHIPS FREE TO THE LOWER 48 STATES 0934-3019 Moose Racing Gasket Kit Fits Outlander/Renegade 800 models. Complete kit with oil seals. Center case gasket Magneto Cover Gasket PTO Cover Gasket Two Cylinder base Gaskets Two Cylinder Head Gaskets Two Valve Cover Gaskets Water Pump Cover Seal (kit does not come with mechanical seal)
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.
Free shipping on most domestic orders over $99 Dismiss