Driveshaft

  • NEW OEM Can-am rear driveshaft retaining bolts. Don’t know your size? These are the two most common sizes. M12 x 16 and M10 x 16 with washers. Ships exactly as pictured. On the M12x16 bolt we recommend adding thread locking compound before installation. Thread pitch is 1.25
  • NEW Prop Shaft Low profile pair of clamps for 715900118 boot. Clamps also work for G2 front shaft boot 705401093. The last few pictures show the clamps loose, then installed nice and tight. Sold in pairs enough to do one boot.
  • Brand New Genuine OEM Wear ring a must if you are replacing your pinion seal, these are the sacrificial parts that save your drive shaft from grooving! Will fit 18 and 20 Spline Yokes that are fully machined Part Number 705400036
  • Rear driveshaft U-Joint Replacement 398 style Fits all V-twin Canam rear driveshafts XMR XT XXC XDS XRS STD Grease zerk in cap for easy maintenance Made in Japan High Quality Clips are included just as pictured We recommend pumping fresh grease in after installing, as the grease inside may not be enough for operation. Please note on some older driveshafts the yoke ears may need to be ground down to allow for the larger center part of the joint to be installed. Replaces OEM part numbers: 703500846 715900270 715900278
  • New OEM Can-am Part This boot fits the G2 outlander/renegade front driveshaft. It is the thicker tapered boot, some use two of these on G2 atv's front driveshaft. Part number 705401093
  • New OEM Rear driveshaft U-Joint 25mm caps 398 style Fits all V-twin Can Am rear driveshafts Clips are included just as pictured We recommend pumping fresh grease in after installing, as the grease inside may not be enough for operation.
  • Brand New Genuine OEM Rubber Boot Fits Commanders Mavericks Outlanders Renegades Used for sliding joints Part number 715900118
  • SHIPS FREE TO THE LOWER 48 STATES Updated Can-am Rear G2 Outlander/Renegade 2019 and newer prop shaft. All new all OEM Shaft OEM U-joints. OEM protector ring installed Input yoke swapped to 18 spline This is the correct length for short wheel base single seat 500/570/650/800/850 Outlander or Renegade with 1000 XMR rear differential. This will also work on 2015+ Outlander short wheel base, single seat 1000/1000R with 1000 XMR rear differential. Direct replacement for 2015 and newer 800/850 XMR Current Part number: 703500988 Previous Part number: 703500858 703500931 20 spline differential side yoke 18 spline gearbox side yoke No wear ring needed
  • Can-am Rear G2 2012 and newer prop shaft. All New All OEM Shaft OEM U-joints, with OEM gearbox seal protector installed. Correct shaft for Single Seat (SWB) 2012-14 1000 Outlander or Renegade with 1000 XMR rear differential. WILL NOT WORK ON 2015 Outlander 1000/1000R and newer as these have the smaller gearbox. Direct replacement for 2016-Current Renegade 1000R XMR **Please note, this is the most updated shaft and does not require a wear ring on the differential side of the shaft. The last two pictures illustrate this.** 20 Spline Gearbox side yoke 20 Spline Differential side yoke Current Part number: 703500990 Previous Part number: 703500928 703500901
  • NEW Genuine Can-am Rear Prop Shaft for 2012-18 Outlander Or Renegade 500, 570L, 570, 650, 800R or 850.

    Be sure to check part numbers before ordering if you have a 1000.
    This will work on 2015+ Outlander 1000 non XMR/T3 machines (small gearbox).

    This updated shaft does not need wear ring as it is simply machined larger in outer diameter.

    Current Part number: 703500986
    Previous Part numbers: 703500925 703500855 705501406

    18 spline gearbox side yoke
    18 spline differential side yoke

  • SHIPS FREE TO THE LOWER 48 STATES New OEM G2 Front Prop Shaft. These are designed to shear to save more expensive components. Current Part number: 705400913

  • Rear Yoke for use with 398 U joints. This yoke includes the wear ring pressed on. 18 spline count. This slips into standard rear differentials. Part number 715900101 and 705400036

Title