- The Rogue Lock-On grips feature large raised pads for better shock absorption and deep grooves to channel away dirt and debris. Uses the Lock-On Grip System, easy no-hassle installation and 100% slip free performance. MADE IN USA PRODUCT FEATURES: Chunky, oversized grip provides extra shock absorption and improved control Larger grip diameter delivers extra padding, rugged surface pattern for better traction Extra-large raised pads provide shock absorption with deep grooves to channel away dirt and debris Molded inner 1st pass for easy, knock-out-ends for full-wrap handguards Preinstalled ODI V2.1 Lock-Jaw Clamps with screws Patented Lock-On Grip System™ design delivers easy installation and ensures 100% slip free performance
- OUT OF STOCKSHIPS FREE TO THE LOWER 48 STATES New Forged OEM Can-am piston kit with rings. Matched to an OEM Rotax used Cylinder. This is ready to install on your 650 Outlander engine. Two are required per engine. Piston comes with rings installed. Piston pin, and clips are not included. Part number 420684111 420613888
- OUT OF STOCKG2 dual piston brake calipers with pads. Genuine OEM parts. This set of three calipers will fit G2 Renegade and Outlander 2012+ Part numbers 705600861 705600862 705600859 Cleaned greased and ready to install.
- OUT OF STOCKNEW Outsiders Mud Crew Airbox seal This is an improved design over factory Apply a small amount of grease to aid install, this is much thicker and denser than the OEM o-ring or gasket Replaces OEM part numbers: 293300165 293300175 293300179
- OUT OF STOCKInline fuel controller, this unit takes the fuel signal and modifies it based on throttle position and RPM inputs. Part number FC25009, please contact us if you have fitment questions. You can use a pre built map table or build your own custom map. Software is compatible with Power Commander, so you can download Power Commander maps to the unit Plug-n-play fuel management device pre-programmed with make/model specific maps Fully adjustable computer compatibility for ultimate tuning and personalization Use OEM-style connectors and high-quality wiring harnesses No computer necessary to modify fuel management Small, lightweight, and easy to fit on your bike Integrated O² optimizer where applicable
- This is the 2019+ rear differential found in Renegades and Outlanders 650 and larger This has the 6 inch (155mm) ring gear with straight cut teeth as shown. It will fit g2 bikes (500/650/800/1000) if you are upgrading you will need to shorten your shaft 1.75 inches or buy a kit from us, please see our other listings. (G1 bikes will require further modifications to work). This has a provision for an abs sensor, but will fit bikes without a rear diff sensor BRP claims 25% increase in load capacity on this gear set vs the spiral cut xmr final drive units (rear differentials) from 13-18 models. Pinion spline count 20 Current part number 705502808
- Rear driveshaft U-Joint Replacement 398 style Fits all V-twin Canam rear driveshafts XMR XT XXC XDS XRS STD Grease zerk in cap for easy maintenance Made in Japan High Quality Clips are included just as pictured We recommend pumping fresh grease in after installing, as the grease inside may not be enough for operation. Please note on some older driveshafts the yoke ears may need to be ground down to allow for the larger center part of the joint to be installed. Replaces OEM part numbers: 703500846 715900270 715900278