- LED dimmer facilitates reading temperature settings. 4 temperature settings with individual controls for thumb and grips. Returns to previous heat setting. One-touch shutdown. Compatible with Intelligent Throttle Control (ITC). Wiring Cable (710004567) is required for installation on G2 650 and G2L 570.
- SHIPS FREE TO THE LOWER 48 STATES OEM BRP Heated Grips and Thumb kit.
- Updated Can-am Rear G2 Driveshaft Fits: 2019+ Outlander 1000R (excluding MAX and XMR) 2019+ Outlander 650/850 (excluding MAX) 2019+ Renegade 650/850 All new all OEM Shaft OEM U-joints. OEM protector ring installed Gearbox side yoke swapped to 18 spline Current Part number: 703500988 Previous Part number: 703500858 703500931 If you have a 2019+ 570 short wheel base single rider, this may be the correct shaft for your application, the parts fiche may not show the correct part number. You will need to measure the outer diameter of your rear differential's pinon seal, this shaft will only work with machines that have a 80mm pinion seal. If you measure 70mm you will need 703500986. 20 spline differential side yoke (fits 705502808/705502546 rear differential) 18 spline gearbox side yoke (small gearbox size) No wear ring needed, the deferential side yoke is machined to the outer diameter that a wear ring would be.
- All Balls complete fuel pump module, retaining nut and gasket This fits G1 Models: 2009-2015 EFI Outlander 400 2009-2012 Outlander or Renegade 500 2009-2012 Outlander 650 2009-2011 Outlander 800R 2012 Outlander 800R XMR 2012 Outlander 800R MAX 2009-2011 Renegade 800R Part number: 47-1049 24-71022 Replaces OEM numbers: 703500766 703500781 709000194 709000245
- OUT OF STOCKNEW Outsiders Mud Crew Airbox seal This is an improved design over factory Apply a small amount of grease to aid install, this is much thicker and denser than the OEM o-ring or gasket Replaces OEM part numbers: 293300165 293300175 293300179
- OUT OF STOCKNEW OEM BRP Thermostat Current part number 709200406 replaces 709200383 This style is external from the cylinder head. If you are unsure on fitment please contact us.
- OUT OF STOCKInline fuel controller, this unit takes the fuel signal and modifies it based on throttle position and RPM inputs. Part number FC25009, please contact us if you have fitment questions. You can use a pre built map table or build your own custom map. Software is compatible with Power Commander, so you can download Power Commander maps to the unit Plug-n-play fuel management device pre-programmed with make/model specific maps Fully adjustable computer compatibility for ultimate tuning and personalization Use OEM-style connectors and high-quality wiring harnesses No computer necessary to modify fuel management Small, lightweight, and easy to fit on your bike Integrated O² optimizer where applicable
- Kit includes one universal boot, one reusable cone tool, two stainless steel clamps, grease pack, and silicone cone lube and instructions Expandable universal CV boot, slides and expands over reusable cone tool for trail side CV boot replacement Lithium based molybdenum grease ensures good lubrication for long CV joint life XL version of the original EZ Trail boot designed to fit UTVs and large ATVs Material is expandable yet tough enough to be a permanent fix Two clamping diameters ensure a good fit on most vehicles Boot material stays flexible in extreme cold temperatures
- Set of four Moose gas shock kit for G1 Outlander 650/800 or Renegade 500/800 These shocks are the same length on all four corners, you may notice a slight lift, more so on a well used machine. *Please note these will not work in place of struts found on the Outlander 400/500 machines. Features: Moose gas shocks offer long term consistent performance over stock oil only damped shocks 10% stiffer springs provide a better ride and higher load capacity Works great on the front to better support your snowplow and on the rear when hauling cargo Smooth black color blends perfectly on your machine Direct bolt-on replacement: pre-installed spring allows for quicker setup P/N13102146X4
- New aftermarket 91mm bore piston and cylinder kit with gaskets rings wrist pins and circlips 10.5:1 compression ratio This is a ready to bolt on kit Fits: Commander 1000 ATV 1000/1000R Defender HD10 and DH9 Maverick Sport 1000 Please note this kit will not fit the SXS 1000R due to the lower compression ratio. No dowel pins included, you will need to transfer these from your engine Replaces OEM Part Numbers: 420685242 420685248 420623568 420623566 420630210 420245436 420216351 420685244 420296774
- MOOSE RACING HARD-PARTS Tie-Rod Upgrade Kit 0430-0673 Fits G1 ATV 2006-2012 Will not fit G2 800R 2012 models, if you have fitment questions please ask. Replaces oem numbers 709400485 709400487 709402303 709400486 This kit upgrades your 10mm factory tie rods to 12mm LH and RH threaded rod for on machine adjustments Sold as a pair
- OUT OF STOCKNEW OEM BRP Rotax Engine. 2016+ ATV 850 Vtwin 78 horsepower@ 7300 RPM, 94mm bore, 61.5mm stroke, 10.5:1 compression ratio. The 850 will have the larger valves when compared to the 800R, these were first seen in the 2013 1000R maverick engine, these are 36.5mm and 31mm respectively. This is new, not rebuilt. It will ship as pictured. No electronics included, you will need to transfer over your parts. Shipped with signature required.
- OUT OF STOCKThis is the NEW OEM factory gauge support from the 2013-19 Outlander XTP and DPS models. LCD Style Speedometers. Part Number: 705006321
- Sale!Brand New Klotz Full Synthetic Oil Change Kit. Ultra convenient “all in one” kit saves time and money. For Can-am off road vehicles with 500cc or larger Vtwin Rotax engines. Excludes Traxter and Quest. Not compatible with Maverick X3 Includes 3 quarts synthetic oil 10W50, 0-ring , Highflow HF152 oil filter, and copper washer for both old style and new style drain plugs. 10w50 oil, great for hot climates, temperature range -13*F to 122*F Will not ship in original box
- New OEM Canam CVT Air Intake pre-filter Fits 2013+ Outlander G2 with the round CVT intake duct inlet. Part # 715003483 Adds extra protection to your engine in harsh riding conditions. Filter blocks particles larger than 0.007" (0.19 mm). Easy, tool-less installation. Necessary to maintain vehicle warranty when tracks are installed. Standard on Outlander 650 X mr, 850, 1000, 1000R engines & G2L PRO. Not compatible with Snorkel kits