NEW OEM Can-am Output Crank Shaft Seal This is the engine out put shaft seal, pressed into the crankcase PTO cover 34mm Inner Diameter 52mm Outer Diameter 8mm Thick Current Part Number 420631933 Replaces Part Number 420631932
SHIPS FREE TO THE LOWER 48 STATES 0934-3019 Moose Racing Gasket Kit Fits Outlander/Renegade 800 models. Complete kit with oil seals. Center case gasket Magneto Cover Gasket PTO Cover Gasket Two Cylinder base Gaskets Two Cylinder Head Gaskets Two Valve Cover Gaskets Water Pump Cover Seal (kit does not come with mechanical seal)
SHIPS FREE TO THE LOWER 48 STATES New Throttle Handle and 4×4 Switch Current Part Number: 707000595 Old Part Numbers: 709400186 707000369
NEW OEM Mode Switch Menu/Trip Found on 2020+ Outlander 850 1000R Part number 710006717
Moose Racing Radiator Cap Fits Outlander, Renegade, Commander, Defender and Maverick Unsure on fitment, please ask us. Cap is set to the same 15.9PSI as stock. If you current cap is not holding pressure replacing with new will help avoid overheating. Replaces OEM 709200207 709200033
Genuine OEM Start/Stop Switch
This has the additional single light blue wire with connector.
Current Part Number: 710006134
Fits some 2019 Outlander and Renegade 1000R, 2020 Outlander and Renegade 850/1000R
Please contact us if you are not 100% sure on fitment, we will be happy to assist
Set of four Bronco gas shock kit for G1 Outlander 650/800 or Renegade 500/800
These shocks are the same length on all four corners, you may notice a slight lift, more so on a well used machine.
*Please note these will not work in place of struts found on the Outlander 400/500 machines.
Features:
Bronco gas shocks offer long term consistent performance over stock oil only damped shocks
10% stiffer springs provide a better ride and higher load capacity
Works great on the front to better support your snowplow and on the rear when hauling cargo
Smooth black color blends perfectly on your machine
Direct bolt-on replacement: pre-installed spring allows for quicker setupP/N AU04414X4
- OUT OF STOCK
OEM Radiator Relocate Kit. This moves your radiator (not included) up on your front rack. This is a must for tackling extreme mud conditions where you risk clogging your radiator and overheating your engine! Allows for easy servicing (cleaning) This is a factory OEM kit, not an aftermarket kit, instructions are provided on BRP’s website. Coolant overflow tank is included, hoses ect.. You will not find a better fit and finish kit on the market. There is drilling and cutting involved. This is all covered in great detail. Roughly 3.5 hour install time This kit fits G2 and G2L models check out the pictured fitment chart if you are unsure what you ride. The white “can-am” is a protective film that can be removed with a small pick. Part number 715001930
NEW Genuine Can-am Rear Prop Shaft for G1 STD single seat machines WILL NOT FIT MAX. This will work with 2006-2011 500 650 800 800R, Outlander or Renegade and 2012 Outlander 500 650 or Renegade 500. The picture is what you will get. We install the wear ring and deflector ring for fast install. Current Part number: 703500801 Previous numbers: 703500767 703500719 705500816 703500704
Brand new inner secondary clutch This inner clutch has the hole for the pig tale style spring but will work on springs without the pig tale. New OEM Part Part Numbers : 420280499 420280235 420248233 420280236 420280238 420280497
Air Pressure sensor, this goes in the Black plastic Intake manifold. Will work on any 2006 to current Can am Outlander, Renegade, Commander, Maverick, Defender 500 570 650 800 850 1000 XT XMR MAX or XXC The Manifold Absolute Pressure sensor or MAP sensor is a sensor that is attached to the intake manifold. The MAP sensor responds to changes in the intake manifold pressure (vacuum) and provides a reading of engine load. How it works is 5 volts DC is supplied to the sensor from the ECU. Inside the MAP sensor there is a resistor that moves in relation to intake manifold pressure. The resistor varies the voltage between about 1V to 4.5V (depending on engine load) and that voltage signal is returned to the PCM to indicate manifold pressure (vacuum). This signal is essential for the PCM to determine fuel delivery. Part numbers: 420874650 707000564 707000995 0 261 230 030 ALFA ROMEO 46553045 ALFA ROMEO 46533518 CHERY S21-3614021 FIAT 46553045 FIAT 77364869 FIAT 7084986 FIAT 0000046553045 FIAT 46533518 LANCIA 46533518 LANCIA 0000046553045 LANCIA 46553045 MOOSE 2120-0994 PROTON PW810694 ROTAX (BOMBARDIER-ROTAX GMBH) 874 650 SCANIA 5166434
OEM Rotax Cylinder Base gasket Fits many Canam ATV’s/UTV’s 330 400 500 650 800 1000 Unsure on fitment? Please ask! Part number 420630210
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.