- 2012-2018 G2 ATV Rear Differential Swap Kit Kit includes: Rear Differential, Rear driveshaft, Bolt and Washer. This kit includes a rear differential with: Tapered roller bearings Three bearings on the pinion gear 6 inch diameter ring gear Your choice of gear style, spiral bevel or straight cut. Both have the same 3.60 ratio as your current differential. Spiral Bevel Gears are sourced from the 2013-18 800 850 and 1000 XMR differentials. Current part number 705502546 Old part numbers: 705502178 & 705502090 Straight Cut gears are sourced from the 2019+ 650+ differentials. Current part number 705502808 The driveshaft included is an OEM shaft with the correct end yokes for your application. The differential end yoke will not use a wear ring, this has been done away with by BRP the yoke is what the pinion seal touches now. You will need to fill the differential with 250ml (8.4oz) of 75W-140 gear oil and transfer over your fill plug and washer. The torque spec on the driveshaft retaining bolt is 55ftlbs with thread locker applied. Some minor trimming on the brackets that surround the differential is required. These differentials have the provision for an ABS sensor, this is standard on euro models, for mud riders state side, you can fill this hole with RTV or leave it open. If you are running the silver protector ring on your axle, you will need to push the ring outward slightly. We choose to remove these dust covers as they tend to trap debris when run under water.
OEM Snorkel kit, this raises the engine air intake well above the handlebars. The ECU is relocated to allow for CVT breather tubes to extend upward. This kit includes the brackets for the two plug type ECU found on ride by wire outlanders. With the tubes molded specifically for this application this is the cleanest kit you can install on your machine. Part number 715005999 Installation time is approximately 3.5 hours This snorkel kit is not compatible with the XT Handlebar Protector Kit (P/N 715000271) 715005999 instructions
- Can-Am 703500865 Secondary Clutch Driven Pulley Stud Nut Screw Kit Secondary Stud/Nut Kit M10x136mm You will need to reuse your washer. This kit will work on every Vtwin ATV factory driven (secondary) clutch (pulley) Also fits Commander driven clutch Will work on non QRS Maverick driven clutch If you have fitment questions, please contact us, we are here to help. Part numbers: 703500865 420441900 420242097 420242402
- OUT OF STOCKGenuine Can Am 800R/1000 Green Fuel Injector OEM Part Part number: 420874833 replaces 420874830
- For use with all BRP turn key type ignition switches. Will not fit RFID type ignitions. Simply cut off the old harness and use the included butt connectors or solder the connections to the new pigtail. Be sure to match up one wire at a time when installing, this helps avoid switching wire orientation as the wires are not color coded. The wires are 6” long so it can be fixed inside the headlight pod Sold each; includes butt connectors and zip ties Part number 2120-0943
- New aftermarket 91mm bore piston and cylinder kit with gaskets rings wrist pins and circlips 10.3 compression ratio This is a ready to bolt on kit, this will work with 800HO 800R and 650 engines. If you install this on a 650 you will need to have your ecu flashed or a inline tuner installed. No dowel pins included, you will need to transfer these from your engine Replaces OEM Part Numbers: 420296775 420685714 420613586 420296774 420216270 420845106 420630210