OEM O ring this seals the gearbox oil, it is installed on the rear through shaft bearing housing. Roughly two inches in diameter. Part Number 420230306 replaces 420230305
BOYESEN SUPERCOOLER WATER PUMP Cover and Impeller Kit Increased coolant flow at all rpm ranges Patented Nautilus-style impeller for hydrodynamic efficiency Color/Finish: Black, Powder-Coated Material: Aluminum Model: Supercooler Part number 0932-0166 WPK-80B Replaces OEM 420222505 420222785 703501124 This is the style with the smaller output nipple roughly 7/8 inch in outer diameter.
SHIPS FREE TO THE LOWER 48 STATES! Can-am NEW OEM Main bearing set. Kit includes: Main Bearing Half with Oil hole 420233965 x2 Main Bearing Half without Oil hole 420233960 x2 PTO Cover Bearing 420233995 Be sure to mark your cases before pressing them out! The oil holes need to be lined up!
NEW OEM Can-am Output Crank Shaft Seal This is the engine out put shaft seal, pressed into the crankcase PTO cover 34mm Inner Diameter 52mm Outer Diameter 8mm Thick Current Part Number 420631933 Replaces Part Number 420631932
New OEM can-am input or output seal for small gear boxes You will need two per gearbox. 32mm inner diameter 47mm outer diameter 7mm thick Current Part Number 420950089 Replaces Part Number 420950087
This is the 2019+ rear differential found in Renegades and Outlanders 650 and larger This has the 6 inch (155mm) ring gear with straight cut teeth as shown. It will fit g2 bikes (500/650/800/1000) if you are upgrading you will need to shorten your shaft 1.75 inches or buy a kit from us, please see our other listings. (G1 bikes will require further modifications to work). This has a provision for an abs sensor, but will fit bikes without a rear diff sensor BRP claims 25% increase in load capacity on this gear set vs the spiral cut xmr final drive units (rear differentials) from 13-18 models. Pinion spline count 20 Current part number 705502808
Brand New Genuine OEM Fill Level Plug Be sure that yours looks the same due to other styles for front or rear differential from different years M14 diameter 1.5 thread pitch Part number 705500504
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit.
Ultra convenient “all in one” kit saves time and money.
For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest.
Not compatible with Maverick X3
Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 5W40, 0-rings, rotax oil filter, and copper washer for old style and new style drain plugs.
May not ship in original box
Part Number: 779258 replaced by 9779488
1652 NEW OEM Needle bearing 16x22x19 Size These are OEM Canam Bearings high quality brands like NTN are used. 16mm Inner Diameter 22mm Outer Diameter 19mm Long Part number 705502058
Brand New Genuine OEM Rubber Boot Fits Commanders Mavericks Outlanders Renegades Used for sliding joints Part number 715900118
Gearbox Shift Shaft Seal 28mm OD 12mm ID 7mm Thick Part numbers: 711250450 420250450- OUT OF STOCK
SHIPS FREE TO THE LOWER 48 STATES New Forged OEM Can-am piston kit with rings. Matched to an OEM Rotax used Cylinder. This is ready to install on your 650 Outlander engine. Two are required per engine. Piston comes with rings installed. Piston pin, and clips are not included. Part number 420684111 420613888 
SHIPS FREE TO THE LOWER 48 STATES Complete Engine Gasket Kit With Oil Seals Fits 500 and 650 Outlanders and 500 Renegades We have used these in many engines with great success. Part number 0934-3018 Replaces OEM 420684145, 420684141
OEM Rotax Piston Ring Set for 400, 800, and 1000cc engines 91mm bore size Complete kit for one factory piston Part Numbers: 420296774 420685244
Replaces OEM 703500836 Japan Made Uncaged Needle Bearing 20X27X15mm Needle Bearing for XMR rear differential pinion gear
Left Side Front or Rear for G2 ATV 2012 with dual piston calipers 2013-19 To current G2/G2L One Caliper Set Part number: DP515 1721-1448 Replaces OEM # 715900248 705601015 DP Brakes Brake Pads are designed with sintered metal compounds to give your ATV high-tech performance in all conditions Pads have a quick break-in period so you get maximum performance fast DP Brakes design and materials ensure consistent, hard stops and fade-free performance Sintered metal compounds outlast more conventional organic or aramid fiber pads
Right Side Front or Rear for G2 ATV 2012 with dual piston calipers 2013-19 To current G2/G2L One Caliper Set Part number: DP516 1721-1449 Replaces OEM # 715900249 705601014 DP Brakes Brake Pads are designed with sintered metal compounds to give your ATV high-tech performance in all conditions Pads have a quick break-in period so you get maximum performance fast DP Brakes design and materials ensure consistent, hard stops and fade-free performance Sintered metal compounds outlast more conventional organic or aramid fiber pads
Used ECM (computer) with OEM Digital Key.
This pair is tested, cleared of any codes and run on our shop ATV before leaving. Your Dash (speedometer) may need to be paired with BUDS. If you want to start and run the machine simply unplug the dash before installing the ecu. We provide the pairing service free of charge with purchase of ECU or Dash, contact us for further details.
Only fits Generation 1 ATV Outlander 650 2006 2007 2008 2009
please note 2010 models use a different style ECU, this will not work on 2010 and newer
Part Number: 420266501 420266505 710000817
Used 800 R ECM (computer) with OEM Digital Key.
This pair is tested, cleared of any codes and run on our shop ATV before leaving.
Your Dash (speedometer) may need to be paired with BUDS. If you want to start and run the machine simply unplug the dash before installing the ecu. We provide the pairing service free of charge with purchase of ECU or Dash, contact us for further details.
Only fits Generation 1 ATV’s Outlander 800R 2009 2010 2011 2012 MAX and Renegade 800R 2009 2010 2011
Part Number: 420266733 42026673, 420266738, 710000817
Used ECM (computer) with OEM Digital Key.
This pair is tested, cleared of any codes and run on our shop ATV before leaving.
Your Dash (speedometer) may need to be paired with BUDS. If you want to start and run the machine simply unplug the dash before installing the ecu. We provide the pairing service free of charge with purchase of ECU or Dash, contact us for further details.
Only fits Generation 1 bikes Outlander and Renegade 800 HO 2006 2007 2008
Part Number: 420266374 420266623 710000817
NEW Genuine OEM Coolant Temperature Sensor This screws into the cylinder head Part Number 278002895
New Genuine OEM CVT Cover Drain Plug This clamps on to your outer cvt cover. Part number 707001179
New G2 dual piston Right Rear brake caliper with OEM pads. Fits G2 Renegade and Outlander 2012-current Genuine OEM part. Part number 703500969
Please verify your differential uses this style of Seals before ordering! Can Am Front Differential Pinion and Axle Seals (Timken) Fit on most all 2006-2019 Outlanders and Renegades Also fits Commanders and Mavericks (non X3/Sport/Trail) The Pinion Seal has a 70mm Outer Diameter And the standard 37mm inner diameter. Replaces part numbers 705401481 705500255 705500081 The Axle Seal has a 47mm Outer Diameter And the standard 25mm inner diameter. Replaces part numbers 705401618 705401486 Complete Seal kit for Standard Front Differentials
New OEM Can-am Part This boot fits the G2 outlander/renegade front driveshaft. It is the thicker tapered boot, some use two of these on G2 atv's front driveshaft. Part number 705401093
NEW Prop Shaft Low profile pair of clamps for 715900118 boot. Clamps also work for G2 front shaft boot 705401093. The last few pictures show the clamps loose, then installed nice and tight. Sold in pairs enough to do one boot.
Outlander Renegade Commander Maverick Differential Drain Plug Brand New Genuine OEM Drain Plug 9.9 mm outside diameter Will fit on some fronts and rears be sure yours looks like this one and measures the same Part Number 705500894- OUT OF STOCK
Brand New Genuine OEM Start/Stop Switch This is the new up to date switch Brand New still in original box Will come as pictured Works on many V-twin ATV’s Renegades and Outlanders will not work on 400’s please look at the plug style on your current switch. The buttons may be arranged differently we have found they will work on all V-twins DPS or non DPS 2006 to 2012. Part number 710000791 710004618 - OUT OF STOCK
New OEM Plastic Shift Arm Base Fits G2 Outlander or Renegade Part numbers: 707000971 707002439
UNI Air filter for G2 Can-am ATV’s UNI part number: NU-8708ST P/U number: 1011-2894 Replaces OEM part number: 707800371 Unsurpassed in airflow, stopping dirt and overall performance You will need to oil this filter before use. Two-stage air filters come apart for maximum airflow and ultimate cleaning Most filters feature the Ultra Seal grease groove on the sealing surface Each fits in stock airbox exactly like OEM filter Clean easily with grease-cutting dish washing detergent; just clean, oil and reuse indefinitely Made in the U.S.A.
HD Clutch bolt set for most every Can-am V-twin 2006 to current. Will not work on: Maverick Turbo Maverick X3 Maverick Sport Maverick Trail Defender These will swap out the factory Torque To Yield (TTY) bolts/studs. M10 and M12 Black-Oxide Alloy Steel Socket Head Bolt These are class 12.9 bolts, with a tensile strength of 170,000 psi, these alloy steel bolts are stronger than Grade 8 steel bolts. 8 and 10mm Allen Sockets required to install these bolts. 18-8 Stainless Steel Single-Wave Washers included, these help prevent loosening, use with your existing washers. Installation Torque Specs: 80 ft·lb On the Primary Bolt 45 ft·lb On the Secondary Bolt (red thread locker recommended, allow to set up overnight)
New short wiring harness for rear tail lights Will need to be wired in to work. This plugs in to Tail light part number 710001645 Fits: G2 ATV's with dual tail lights, Commanders, and Mavericks (non X3/Sport/Trail)
20 Spline Yoke with Wear ring installed. Fits: XMR 1000, Maverick and '14&newer Commander style Rear differentials. These yokes are made to very tight tolerances, if you are not careful when installing these you can damage the yoke or your pinion shaft. We recommend you take your time and clean the pinion gear before installing. ---Great for custom applications--- Uses Factory size U joint (398 at the auto parts store) Part numbers 715900271 705400036- Sale!
New take off gearbox side, 20 spline yoke. This fits on large gearboxes output shafts. 20 spline yoke partially machined to accept a protector ring. This is the forward most yoke on the REAR driveshaft. Works with 398 U joints. found on Vtwin rear driveshafts. Part number 715900129 replaces 705501373 and 715900234 
Black wrap around wind deflector set with mounting kit. Fits Outlander, Renegade, & DS450. Both are brand new. Part numbers 715001378 715001706
White wrap around wind deflector set with mounting kit. Fits Outlander, Renegade, & DS450. Both are brand new. Part numbers 715000537 & 715001378
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.