Used- Good Condition OEM Can-Am Grab Handle for Commander & Maverick Product Number: 705203332 Comes as Pictured
OEM Rear Differential Axle Seals (Set of 2)
Fits on most 2013-Current Mavericks, Outlanders and Renegades
52mm Outer Diameter (which is larger than earlier Diffs)
30mm inner diameter.
Comes as a Pair to do both Left and Right sides of the Differential
705501556 Part number
Oring that replaces 705501880 Buna-N 70 Duro (NBR) This is used on 2014-19 Commander rear differential (without unlocking rear) pinion gears
Brand NEW EPI Upper Ball Joint
For Gen 2 bikes, Commander and Maverick (non Sport/Trail/X3)
Includes Circlip, Cotter Pin, Hardened Washer, and Nut.
Replaces OEM #: 706202044
Manufacturer Part Number: WE350043
High quality Timken oil seal. Replace a leaking front output seal on your canam. This is the seal that seals the engine through shaft coming out of the front of your Vtwin engine below the front exhaust header. To be 100% sure on fitment, measure your outer diameter on your seal, it should read 47mm This seal has a 25mm inner diameter 47mm outer diamter and is 7mm thick. Replaces OEM part numbers: 420430588 420430589 420430580
This model type is a rubber O.D. seal with two sealing lips. The main sealing lip is spring loaded. This is a two-way seal, which means that it can retain lubricant and exclude contaminants simultaneously Canam Vtwin crankshaft main seal. Replaces OEM number 420631933 This seal is pressed into the PTO cover on v-twin's Unsure on fitment? Just measure you seal. 52mm Outer Diameter 34mm Inner Diameter 8mm Thick- Sale!
New take off gearbox side, 20 spline yoke. This fits on large gearboxes output shafts. 20 spline yoke partially machined to accept a protector ring. This is the forward most yoke on the REAR driveshaft. Works with 398 U joints. found on Vtwin rear driveshafts. Part number 715900129 replaces 705501373 and 715900234 
SHIPS FREE TO THE LOWER 48 STATES Set of Bearings and Seals to Rebuild Your Front Differential on Your Can-Am Fits Most Can-Am Models from 2007-Current (WILL NOT FIT Maverick X3/Sport/Trail or Defender) This Kit has High Quality Aftermarket Bearings which are: Timken, SKF, NSK, KOYO, Nachi Comes with: 2 - Carrier Bearings- SKF Brand 2 - Axle Bearings- OEM NSK Japan made 2 - Axles Seals- Timken 1 - Inner Pinion Bearing- Nachi Japan made 1 - Large Pinion Bearing- Koyo Japan made 1 - Pinion Seal
Replaces OEM 529 035 649 529035649 Standard Differential Pinion Nut Removal Tool 1/2 wrench drive Will fit: G1 Front and Rear Diffs 2012-18 G2 Outlander and Renegade Front and Rear EXCEPT G2 XMR 800/850/1000 REAR DIFFERENTIAL Early Commander Rear 2011-13 All Maverick (non x3/trail/sport) and Commander Front Will not fit the 2019 and newer rear differentials with the tapered roller bearings
Spicer Brand U joint for front drive shafts
Fits: G1 Renegade and Outlander . Also works on Outlander 400 Rear shafts.
Maverick/Commander front driveshaftsWill not fit: Maverick X3/Sport/Trail or Defender
Includes clips, and grease fitting.
Pro tip: Install grease fitting before pressing in u joint.
Install u joint in a manner where you can still grease the joint in chassis.Replaces OEM : 715900325 703000023 703000024 703500002 703500135 703500607 703500814
M8x1.25×70 Bolt. m8-1.25x70mm Used to open the secondary clutch on many Can-am ATV’s & SXS’s Simple tool, trusted seller. Or just use these specs and head to your hardware store.
Rugged wheels spacers are made from T6061 aluminum alloy and are precisely CNC machined for accurate dimensions. Spacers can be direct bolt on and can use OEM studs. If you are looking to widen the stance of your machine, clear larger tires or get some new wheels. These spacers are just what you need. These spacers are sold as a pair. Two inch thick The bolt pattern is 4x137mm M10 studs Part number PAWS-1037
Rugged wheels spacers are made from T6061 aluminum alloy and are precisely CNC machined for accurate dimensions. Spacers can be direct bolt on and can use OEM studs. If you are looking to widen the stance of your machine, clear larger tires or get some new wheels. These spacers are just what you need. These spacers are sold as a pair. 1.5 inch thick The bolt pattern is 4x137mm M10 studs Part number PAWS-1036
Rugged wheels spacers are made from T6061 aluminum alloy and are precisely CNC machined for accurate dimensions. Spacers can be direct bolt on and can use OEM studs. If you are looking to widen the stance of your machine, clear larger tires or get some new wheels. These spacers are just what you need. These spacers are sold as a pair. One inch thick The bolt pattern is 4x137mm M10 studs Part number PAWS-1035
Moose Racing Radiator Cap Fits Outlander, Renegade, Commander, Defender and Maverick Unsure on fitment, please ask us. Cap is set to the same 15.9PSI as stock. If you current cap is not holding pressure replacing with new will help avoid overheating. Replaces OEM 709200207 709200033
NEW Speed Sensor Quad Logic brand Will fit 2006-Current Outlander, Renegade, Maverick, Maverick X3, Commander, and Defenders 2210-0568 500-1024 Replaces OE Numbers 420265621, 420265622, 420265624, 420265625, 420265626, 420265629, 707000745 and 711265622
NEW Prop Shaft Low profile pair of clamps for 715900118 boot. Clamps also work for G2 front shaft boot 705401093. The last few pictures show the clamps loose, then installed nice and tight. Sold in pairs enough to do one boot.
Can Am OEM Upper ball joint NEW OLD STOCK Part number is 706201394
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit.
Ultra convenient “all in one” kit saves time and money.
For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest.
Not compatible with Maverick X3
Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 5W40, 0-rings, rotax oil filter, and copper washer for old style and new style drain plugs.
May not ship in original box
Part Number: 779258 replaced by 9779488
BRAND NEW Can Am OEM Wheel Cap This is for a set of Four (4) Caps Part Number 705400928 There is more than one style. Please verify that this is the correct style BEFORE ordering.
BRAND NEW Can Am OEM Wheel Cap This is for ONE (1) Single Cap Part Number 705400928 There is more than one style. Please verify that this is the correct style BEFORE ordering.
Brand New Genuine OEM Wear ring a must if you are replacing your pinion seal, these are the sacrificial parts that save your drive shaft from grooving! Will fit 18 and 20 Spline Yokes that are fully machined Part Number 705400036
NEW OEM Wear Plate This mounts between the bushing and frame mount. Part number 706201063
Brand New OEM Water Pump Rotary Seal. Will fit most Can-Am models. Part Number 420650370
OEM Can Am washer for plastic insert 707900133 This is ONLY for the washer Insert is NOT included (only pictured for reference) Part Number: 503189273
NEW OEM Can-am Output Crank Shaft Seal This is the engine out put shaft seal, pressed into the crankcase PTO cover 34mm Inner Diameter 52mm Outer Diameter 8mm Thick Current Part Number 420631933 Replaces Part Number 420631932
NEW OEM Voltage Regulator Converts AC voltage from the stator to DC voltage used to charge the battery. Part Number 710001191 This is the 650watt version compatible with many ATVs with DPS if you have fitment questions please ask!
Brand New Genuine OEM Valve Cover Gasket. Will work on most Can Am engines from 2003 through current, front or back cylinder. Part number 420630260 replaces 420630262
OEM Rotax Cylinder Base gasket Fits many Canam ATV’s/UTV’s 330 400 500 650 800 1000 Unsure on fitment? Please ask! Part number 420630210
New OEM Engine Case Half Gasket. Fits most G2 Can-Am V-Twin Engines. This is for the longer stroke (75mm) cases. Old Part Number: 420651225 New Part Number: 420651227
NEW Can Am OEM Cam Timing Tool For holding the cam in place for timing and tightening camshaft sprocket bolts For easy installation of new timing chains or just setting timing. OEM Number 529036268 replaces 529036231
NEW OEM O-rings and hex bolts to install inner CVT cover on most Can-Am V-twins. Works on 7 and 13 bolt inner covers Part numbers: O-rings - 420430407 and 420631087 old numbers 420430408 420631088 Hex Bolts - 420440207 Also has a nut and washer for 1000 cover installation - 232561434, 224061121 Will come as pictured
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit.
Ultra convenient “all in one” kit saves time and money.
For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest.
Not compatible with Maverick X3
Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 10W50, 0-rings, rotax oil filter, and copper washer for both old style and new style drain plugs.
10w50 oil, great for hot climates, temperature range -13*F to 122*F
May not ship in original box
Part Number: 9779252 779252
Brand New Genuine OEM XPS Full Synthetic Oil Change Kit. Ultra convenient “all in one” kit saves time and money. For Can-am off road vehicles with 500cc or larger Rotax engines. Excludes Traxter and Quest. Not compatible with Maverick X3 Includes 2 quarts plus 1 16 fl oz of 4T synthetic oil 0W40, 0-rings, rotax oil filter, and copper washer for old style and new style drain plugs. May not ship in original box Part Number: 779259
New Genuine OEM bushing Fits 2011 and newer Commander front upper a arm Order two per arm Part number 706201062
NEW OEM PART Fits 2011 and newer Commander front upper a arm Order two per machine OEM numbers: 706202445
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.