- OUT OF STOCK
NEW OEM GEARBOX 570s come with a lower ratio gearbox than the normal low ratio gearboxes found in the 650’s and 500’s The extra low ratio gearbox will help bottom end power and with larger tires, this is the lowest ratio small gearbox. Current Part Number 420686569 Replaces: 420686567 420686560 420686561 This is found in Outlander or Renegade 570 DPS XT or XMR Will work in 650,800,850, and 2015 and newer 1000/1000R ATV’s Teeth count and gear ratio Ring & Pinion 38/28 = 1.357 High Gear set 46/20 = 2.300 Low Gear set 31/14 = 2.214 High final ratio 3.341:1 Low final ratio 5.662:1 2015 and newer non XMR outlander 1000’s have this style gearbox, if you have fitment questions, please contact us! If you are installing this on an early G1 ATV you will need to transfer over your gear position sensors. 
Can-am Side by Side (Commander 800 and 1000 and Maverick 1000R) 2011-2017 Upgrade dash set: Dash, Bracket, cover and hardware. All OEM, 0 Miles. Your engine hours will stay with the ECU, be sure to record your miles for your own records. The dash comes in km/h and will require BUDS programming to change it to mph. This can be done at your local dealer or we offer this free of charge with purchase if you would like to stop by or you can send us your ecu, dash, key and if you have power steering we would need the power steering module as well. Updated Speedometer Part Number 710004547 Cluster Support Part Number 707900013 Dash Part Number 707900124 The dash is designed to auto pair, but sometimes it will not auto pair and you will have to program them together with buds software. This can be done at your local dealer or you can send in your ecu, key(s), and DPS (power steering) to us for programming.
NEW OEM Radiator for 2012+ G2 Can-Am Outlander and Renegade ATV’s Should fit all engines and submodels, including XMR Part number 709200286
SHIPS FREE TO THE LOWER 48 STATES New OEM Standard G2 Rear Differential Ring & Pinion Gear Set 1652 There are a few options for kits, please verify your differential uses this style of gears before ordering! This will only fit six mounting hole differentials. OEM Rear Differential Gear set 10/36 Ring and Pinion gear set. The gears are straight cut as pictured. Open up the differential! Check for two bearings total (one on each side) on the ring gear. If you only have two proceed to the next measurement. Measure your outer diameter of your axle seals! They should measure close to 2 1/16? (52mm) To further verify fitment you can measure your pinion pilot shaft, this should be 5/8? (16mm) Please take the time to measure your parts before buying this will save time and restocking fees. Fits 2015 -2019 G2 style ATV 500/570/650/800/850/1000/1000R NON-XMR style REAR differential. 570/650 XMR machines do not have the true XMR differential.
This is the 2019+ rear differential found in Renegades and Outlanders 650 and larger This has the 6 inch (155mm) ring gear with straight cut teeth as shown. It will fit g2 bikes (500/650/800/1000) if you are upgrading you will need to shorten your shaft 1.75 inches or buy a kit from us, please see our other listings. (G1 bikes will require further modifications to work). This has a provision for an abs sensor, but will fit bikes without a rear diff sensor BRP claims 25% increase in load capacity on this gear set vs the spiral cut xmr final drive units (rear differentials) from 13-18 models. Pinion spline count 20 Current part number 705502808
SHIPS FREE TO THE LOWER 48 STATES OEM Outer CVT Cover 2013 Maverick 1000R ONE Breather hole in front of Primary clutch. This is the cover with the most room. Common to use this on newer Vtwin Mavericks with aftermarket clutches that do not require the extra breathers. Current Part Number: 420612313 replaces 420612312 Will not fit Maverick X3/Sport/Trail
Used 800 R ECM (computer) with OEM Digital Key.
This pair is tested, cleared of any codes and run on our shop ATV before leaving.
Your Dash (speedometer) may need to be paired with BUDS. If you want to start and run the machine simply unplug the dash before installing the ecu. We provide the pairing service free of charge with purchase of ECU or Dash, contact us for further details.
Only fits Generation 1 ATV’s Outlander 800R 2009 2010 2011 2012 MAX and Renegade 800R 2009 2010 2011
Part Number: 420266733 42026673, 420266738, 710000817
Canam Outer CVT Cover Commander/Maverick 1000R Please look at pictures to verify fitment. This has two breather holes, one in front of the primary, one on the secondary. This cover is the factory replacement for 420612319, some aftermarket clutches will not clear the new breather hole style you may need to modify this cover or backdate it to the 420612313 style with out the secondary breather. Fits: Commander 1000R two seat 2018-2020 Commander 1000R MAX four seat 2018 Maverick 1000R two seat 2014-2018 Maverick 1000R MAX four seat 2014-2018 Will not fit: 2015-2018 Maverick 1000R Turbo 2017-2018 Maverick 1000R XMR If you have questions please ask! Current Part number 420212286 replaces 420612319 420612470
- OUT OF STOCK
OEM Snorkel kit, this raises the engine air intake well above the handlebars. The ECU is relocated to allow for CVT breather tubes to extend upward. This kit includes the brackets for the two plug type ECU found on ride by wire outlanders. With the tubes molded specifically for this application this is the cleanest kit you can install on your machine. Part number 715005999 Installation time is approximately 3.5 hours This snorkel kit is not compatible with the XT Handlebar Protector Kit (P/N 715000271) 
Early Commander Steering Rack Great Value for replacing a worn out rack. Moose Number 0430-1071 Replaces OEM 709401185 Fits 2011-2014 Commander 800/1000 Be sure to center rack before installing your steering shaft.
Seat Bottom Fits Commanders, and Mavericks. 800 or 1000 Will not work on Maverick X3/Sport/Trail Current part number 703500943 Replaces part numbers: 708001085 708001102 708001318
New MOOSE UTILITY DIVISION Hi-Performance Cooling Fan - 1300 CFM Fits on some G2 Oultander/Renegade and OG Maverick, please verify your current fan motor has four mounting holes. Will not fit XMR Outlander's Part number 1901-0712 Replacement fan motor fits in part numbers: 709200564 709200309 709200462
Have Questions?
Our staff is available to answer questions
canampartsguy@gmail.com
1340 Okray Ave.
Plover, WI 54467
jared@canampartsguy.com
Cant find What you're looking for?
Visit our 
store!
2016 Can Am Parts, LLC. All rights reserved.