Outlander

  • OUT OF STOCK
    Inline fuel controller, this unit takes the fuel signal and modifies it based on throttle position and RPM inputs. Part number FC25009, please contact us if you have fitment questions. You can use a pre built map table or build your own custom map. Software is compatible with Power Commander, so you can download Power Commander maps to the unit Plug-n-play fuel management device pre-programmed with make/model specific maps Fully adjustable computer compatibility for ultimate tuning and personalization Use OEM-style connectors and high-quality wiring harnesses No computer necessary to modify fuel management Small, lightweight, and easy to fit on your bike Integrated O² optimizer where applicable
  • Slider Blocks for Trailbloc Primary clutches for CANAM ATVS This is a set of six, you will need to transfer over your weights. Part number 0930-3022
  • New Genuine OEM steering stem for G2 Outlander and Renegade This will only fit NON power steering models Will not work on power steering bikes Current Part number 709401008
  • OUT OF STOCK
    NEW OEM BRP Thermostat Current part number 709200406 replaces 709200383 This style is external from the cylinder head. If you are unsure on fitment please contact us.
  • OMC trunk seal for G2 Outlander This is an improved design over factory, this is much thicker and denser foam than the OEM gasket WILL NOT FIT G2L (models with steel racks) Replaces OEM part numbers: 293250275 219704369 293200163
  • OUT OF STOCK
    NEW Outsiders Mud Crew Airbox seal This is an improved design over factory Apply a small amount of grease to aid install, this is much thicker and denser than the OEM o-ring or gasket Replaces OEM part numbers: 293300165 293300175 293300179
  • MOOSE RACING HARD-PARTS Replacement Tie-Rod  Ends 0430-0717 WILL NOT WORK WITH OEM TIE RODS Fits G2 ATV 2012-2018 with upgraded 12mm tie rods kit part number 0430-0674 This kit includes a pair of  12mm LH and RH ends, enough to repair one side of your ATV.
  • OUT OF STOCK
    All Balls complete fuel pump module, retaining nut and gasket This fits G1 Models: 2009-2015 EFI Outlander 400 2009-2012 Outlander or Renegade 500 2009-2012 Outlander 650 2009-2011 Outlander 800R 2012 Outlander 800R XMR 2012 Outlander 800R MAX 2009-2011 Renegade 800R Part number: 47-1049 24-71022 Replaces OEM numbers: 703500766 703500781 709000194 709000245
  • Part number 0950-1011
    This isolates the spring from the one way bearing on a trail bloc primary clutch.
    Measurements as shown

  • Updated Can-am Rear G2 Driveshaft Fits: 2019+ Outlander 1000R (excluding MAX and XMR) 2019+ Outlander 650/850 (excluding MAX) 2019+ Renegade 650/850 All new all OEM Shaft OEM U-joints. OEM protector ring installed Gearbox side yoke swapped to 18 spline Current Part number: 703500988 Previous Part number: 703500858 703500931 If you have a 2019+ 570  short wheel base single rider, this may be the correct shaft for your application, the parts fiche may not show the correct part number. You will need to measure the outer diameter of your rear differential's pinon seal, this shaft will only work with machines that have a 80mm pinion seal. If you measure 70mm you will need 703500986. 20 spline differential side yoke (fits 705502808/705502546 rear differential) 18 spline gearbox side yoke (small gearbox size) No wear ring needed, the deferential side yoke is machined to the outer diameter that a wear ring would be.
  • SHIPS FREE TO THE LOWER 48 STATES OEM BRP Heated Grips and Thumb kit.
    •  LED dimmer facilitates reading temperature settings. 4 temperature settings with individual controls for thumb and grips. Returns to previous heat setting. One-touch shutdown. Compatible with Intelligent Throttle Control (ITC). Wiring Cable (710004567) is required for installation on G2 650 and G2L 570.
    Fits 2020+ models equipped with 850 engine and 2019+ models with 1000R engine, and European vehicles Part Number 715004815
  • NEW OEM Mode Switch Menu/Trip Found on 2020+ Outlander 850 1000R Part number 710006717